Bench type drilling machine – Column and desk stand SERRMAC tapping machine with MDR 32 manual gearbox

Nesne konumu

Üretici firma

Açıklama

When tapping with a guide cartridge (positive feed), the tap / former is guided into the workpiece via the guide cartridge without the usual gate.
The guide cartridge must always match the pitch of the tap used.
This creates a thread with gauges from the very first thread. This system is therefore also suitable for soft material or thin-walled workpieces in order to produce as many load-bearing threads as possible.
Without a cartridge, the machine can also be used for tapping with a chamfer as with a normal drill. The functions of the switching control for right-left rotation are retained.
The extensive function cycles are unique to the SERRMAC MDR series.
(Sensor lever - single cycle - continuous cycle - continuous cycle with adjustable time delay)
The SERRMAC MDR is therefore suitable for both single threads and automated tapping systems.

Technical specifications
Tapping performance steel St. 50 M32 mm
Spindle taper MK 4
Drilling depth 60mm
Projection 300mm
Table size 594 x 344mm (C), 580 x 250mm (P)
Column diameter 123mm
Speed ​​control manual transmission 12-speed (CI)
Spindle speeds 64 - 1,720 rpm
Motor power (400 V - 50 Hz) 2.2 kW
Weight 380 / 310 kg

Executions
Model MDR 32 P: In desk stand design (P) with height-adjustable drill head and cabinet base.
Model MD 32 C: In column version (C) with intermediate table 594 x 344 mm

Standard equipment
Lockable main switch
Electrically locked chuck protection, height adjustable
Machined base plate with T-slots
Depth setting switchover point counter-clockwise, linear in front plate with adjusting screw
1 guide cartridge (slope of your choice)
CE declaration of conformity and operating instructions

Durum

Makine güç altında